![]() ![]() On the YouTube channel, pay attention to the Square One Series. You can reverse this later by right clicking on the proxy component and selecting Restore Component from LO-POLY Proxy from the RpTools submenu. To help achieve your goals, some time spent at the SketchUp Campus and at the SketchUp - YouTube channel will be very worthwhile. ![]() We've already taken a look at Groups and Components in separate videos so today we will be diving. To understand the process, follow the steps given below.Don't forget to check out our site http://ho. We're looking at Groups versus Components. Select OK to create the DUAL-POLY Proxy Component. Creating 2d and 3d Sketchup components is fairly simple.Both on - both the Hi-poly and Low-poly layers are turned on.Hi-POLY on - only the original component geometry is displayed'.LOW-POLY on - only the proxy components are displayed.Wire frame block - in which the component is replaced with a wire frame block representing its extrema.Block with plain faces - uses even less display time.Block with images of the original component.Criss-cross images - in which the component is replaced with a criss-cross of its thumbnail image In this SketchUp tutorial for beginners, we cover how to make solid groups or solid components in SketchUp.Restore original component Removes any proxy data from the selected component. Right click again to restore the full componentĬonvert in place Current component is replaced with a component of the same name with both LO-POLY and HI-POLY geometry stored in separate layers.Ĭreate alternate component Creates a new component, with a different name, which contains the original component in a HI-POLY layer, and contains the LO-POLY geometry in a LO-POLY layer Here is the component displayed as a criss-cross proxy object Right Click on component and select Create LO-POLY Proxy Component You can replace the current component with a component of the same name with both LO-POLY and HI-POLY geometry stored in separate layers, or you can create a new component, with a different name, which contains the original component in a HI-POLY layer, and contains the LO-POLY geometry in a LO-POLY layer. To create a Proxy Component from an existing component, right click on the Component and select Create LO-POLY Proxy Component from the RpTools submenu.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |